SSH 6-9in Handguard
This flared handguard allows any suppressor up to 1.6″ in diameter to be recessed. It features a full picatinny rail and an anti-rotation pin interface between upper and handguard to prevent any chance of rotation. The overall length is 9 7/8″ and internal diameter is 1.75″. The SSH (Suppressor Shield Handguard) Series Handguard is designed for comfort in mind keeping the slim outside diameter of 1 5/8″ that the RO21 Handguard has near the front integration to the upper receiver, then swelling up to 1 7/8″ outside diameter to accommodate the suppressor while still keeping a slim profile. The swell in the handguard also acts as a handstop, protecting the hand from the heat of the suppressor. The directional cutouts not only remove weight but add a complimentary look to the RO21 Receiver Set. This handguard is still lightweight with the added feature, weighing in at 8.7 oz. With barrel nut assembly a total weight of 12.7 oz.
- Full Picatinny Rail
- 1.75″ Inside Diameter
- 1.875″ Outside Diameter
- Overall Length 9.875″
- Suggested Barrel Length of 6″-9″ to allow for recession of suppressor at min. length of 4.5″
- Barrel shoulder to end of handguard is 4.5″. This allows for a shorter suppressor 4.5″ and longer.
- Anti-rotation pin interface between upper and handguard
- Compatible with low profile gas block
- Quick disconnect sling socket at 90° and 270° positions
- M-Lok attachment interface
- Compatible with AR15 Mil-Spec Upper Receivers
- Barrel Nut mounting hardware included
- Type III Hard Anodized
- Weighs 8.7oz
- Shorter M-Lok Hardware for mounting above suppressor is available to purchase separately.
**Disclaimer: Anodizing variates in colors due to die lots affected by environment, climate, humidity, etc.
